These upgrade sets are focused on full hotend upgrade by replacing the stock, or Micro Swiss, with Copperhead™ or Mosquito™ hotends.
Owners re-use the stock thermistor, heater and fans.
No firmware update is required.
Nozzle update is required : from stock to RepRap standard (M6x1x7.5×12.5).
ALL the PH3 Hotend Upgrade Kits are compatible with ALL DDX versions.
Check the available PH1 direct extruder upgrade kits.
The same guide can be used with the Mosquito Magnum.
This Copperhead hotend uses the screw-mount heat sink.
Compatibility table
DDX PH3 Upgrade Kits | Compatible with |
---|---|
PH2 to PH3 Copperhead Upgrade | Creality units upgraded with DDX PH2 |
DDX PH3 Copperhead Upgrade | All Creality units upgraded with DDX |
DDX PH3 Mosquito Upgrade | All Creality units upgraded with DDX |
DDX PH3 Mosquito Upgrade | All Creality units upgraded with DDX |
Visit the Bondtech DDX Direct Drive eXtruder Ecosystem landing page
Find the DDX Step By Step Guides by clicking here.