These upgrade sets are focused on partial hotend upgrade by replacing the stock heat break and hot block with Copperhead units.
Owners re-use the stock thermistor, heater, heat sink and fans.
No firmware update is required.
Nozzle update is required : from stock to RepRap standard (M6x1x7.5×12.5).
The PH2 Hotend Upgrade Kits should be used only with the related DDX version.
Check DDX printer compatibility at the bottom of the PH1 direct extruder page.
How to install a PH2 Upgraded Ender/CR-10 hotend on DDX v3
DDX PH2 is based on Copperhead C-E Heat Break
DDX PH2 is based on Copperhead C-E Heat Break
How to install a PH2 Upgraded CR-10(S) Pro/Max hotend on DDX v3
DDX PH2 is based on Copperhead C-E Heat Break
DDX PH2 is based on Copperhead C-E Heat Break
Compatibility table
DDX PH2 Upgrade Kits | Compatible with |
---|---|
Copperhead™ for Ender/CR-10(S) | Ender-3; Ender-3 Pro; Ender-5; Ender-5 Pro; Ender-5 Plus; CR-10; CR-10 Mini; CR-10S; CR-10 S4; CR-10 S5; |
Copperhead™ for for CR-10(S)Pro/Max | CR-10S Pro; CR-10S Pro V2; CR-10 Max |
Visit the Bondtech DDX Direct Drive eXtruder Ecosystem landing page
Find the DDX Step By Step Guides by clicking here.