Raise3D DualDirect

SKU: EXT-KIT-38.

Raise3D DualDirect

Rated 3.00 out of 5 based on 1 customer rating

$200.00

Bondtech upgrade extruder for RAISE3D DualDirect with dual nozzle.

This kit provides a high-performance material feeding system with the ability to print faster with improved quality. The adjustable thumbscrew allows you to fine-tune the force acting on the filament.

The housing parts are professionally SLS printed in polyamide for maximum strength and precision.

Please Note! On early printers an adapter cable is needed in order to connect the factory cable to the new motor. You can determine if your printer has legacy motors with an easy visual check. Motors that require an adapter will have a silver appearance (unpainted aluminum finish) on the front and rear side of the motor.  If the motors on your printer have a black front and rear motor endplate then you will not need this adapter.

You find the adapter needed at the bottom of this page.

This extruder upgrade kit for the Raise3D N1/N2/N2+ printer will replace the original feeder placed on the printhead.

It allows for a more reliable printing with all sorts of filaments, both stiff and flexibles and the DualDrive system ensures that the extruder never looses grip of the filament so grinding, slipping is a thing of the past.

Original extruder setup on Raise3D is 890g for dual setup, this new upgrade is 425g with the included motors and it allows for faster printing without surface issues due to vibration during accelerations/deaccelerations.

The kit comes with it owns lightweight pancake motors.

The extruder is equipped with two push-fit connectors for 4 mm guide tube that will let you connect the existing guide tubes to the extruder. Tubes are not included.

Installs in about half an hour with standard tools available.

This upgrade fits both the Revision 1 (casted) and Revision 2(cnc-milled) version of the printhead.

Full installation guide available at the tab installation guide.

Installation is done in about 20 minutes.

Plug & Play solution, no need to cut and solder wires.

E-step value: 415

IMPORTANT!!
It has come to our knowledge that if the ribbon cable to the break-out board gets unplugged when the printer is turned on, thermal runway might happen, make sure that the ribbon cable is securly held in place with hotmelt or a zip tie.

Weight600 g
Dimensions15.5 x 11.5 x 10.5 cm

Installation Guide

Download

1 review for Raise3D DualDirect

Show reviews in all languages (1)

There’s a critical typo in the instruction manual regarding rewiring the stepper motor pins – it is instructed to swap the “outermost” pins, then gives confusing directions afterwards about swapping pins 1 and 3. After having burned out my extruder control board I found out that the instructions should have read “leftmost”, not “outermost”, along with specifying the nonstandard orientation of the JST header used to describe the pinswap.

Thankfully, Raise3D designed the extruder control boards to be modular; however, this really dims my view of Bondtech :/

Hi, thanks for the heads up in the instruction, it has now been changed to make it even clearer.
If you changed the outmost wires it can not have caused the damage to your controller (I guess that you talk about the controller board in the printer), the motor would simply not turn since the two coils were not connected. Normally to create a damage to the stepper drivers a short circuit is required (connecting two wires for one coil directly to each other)

I hope that you will enjoy the upgrade and the advantage it gives to your printer
/Martin

Add a review

You may also like…

Raise3D DualDirect on Instagram

Want to share your instagrams of you with your Raise3D DualDirect? Use the #bondtech hash tag.