English
Du har inga produkter i varukorgen.
DDX PH4 300°C 24v 50W for for Ender
- Thermistor capable of reading from room temperature up to 300°C
- 24v 50W Heater for faster nozzle heating-up.
- 125 cm long lead with 3 mm diameter thermistor cartridge.
- 125 cm long lead with 5.95mm diameter heater cartridge<./li>
- Compatible connectors for easy install and service.
455.63kr
Using this product requires updating the firmware.
Check the Firmware tab for a version compatible with your unit.
Recommended component to use with Bondtech DDX for Creality.
Use this component to use PHase 4 of the DDX Direct Drive eXtruder on the following Creality units:
- Ender-3 Pro
- Ender-5 Pro
EAN: 7350011411696
Take good care of your cables
These are highly sensitive components whose quality is focused on the temperature reading or raising performance, not on the mechanical resistance.
Always provide the cables proper strain relief and cable management to minor the damage due to the constant motion.
This product is based on Slice Engineering’s 300°C Thermistor and 24v 50W heater with bare leads.
CR-10(S)Pro and CR-10 Max compatible connectors were added to the product by Bondtech.
Thermistor and Heater by:
| Vikt | 120 g |
|---|---|
| Dimensioner | 11 × 17 × 4 cm |
Firmware
No firmware is available to download at this moment
Please check again soon.
Endast inloggade kunder som köpt den här produkten får lämna en recension.
Relaterade produkter
From: 501.12kr
36.37kr
1,667.87kr
Från: 637.65kr
1,485.58kr
Recensioner
Det finns inga produktrecensioner än.