Using this product requires updating the firmware.
Check the Firmware tab for a version compatible with your unit.
Recommended component to use with Bondtech DDX for Creality.
Use this component to use PHase 4 of the DDX Direct Drive eXtruder on the following Creality units:
- CR-10S Pro
- CR-10S Pro v2
- CR-10 Max
Take good care of your cables
These are highly sensitive components whose quality is focused on the temperature reading or raising performance, not on the mechanical resistance.
Always provide the cables proper strain relief and cable management to minor the damage due to the constant motion.
This product is based on Slice Engineering’s 300°C Thermistor and 24v 50W heater with bare leads.
CR-10(S)Pro and CR-10 Max compatible connectors were added to the product by Bondtech.
Thermistor and Heater by: