English
Du har inga produkter i varukorgen.
Anonymized Chats Transcript
CR-10S extruder mount needs PTFE tube
Conversation started on Friday, February 21 2020, 13:57
[13:58] Customer : Hi, the printed CR-10S Bowden Mount needs PTFE tube inside?
[13:59] Bondtech : Yes a short section pushed into the mount in order to avoid wear of the mount itself.
[13:59] Customer : Guess i have to remove it again 😀
[14:04] Customer : I can’t press it in?
[14:04] Bondtech : Yes that is how we do it
[14:04] Customer : The hole seems too small.
[14:05] Bondtech : It is smaller at the surface, this way it will be kept in place
[14:06] Customer : Does it need to go all the to the other side?
[14:06] Bondtech : No, cut a piece 4 mm long and push it in
[14:09] Customer : Does it need a small piece on both sides?
[14:09] Bondtech : Correct!
[14:12] Customer : Thanks
[14:12] Bondtech : You are welcome!