Showing all 2 results

These upgrade sets are focused on heater and thermistor upgrade by replacing the stock parts with Slice Engineering 50w heaters and 300°C thermistor.

Owners re-use the stock fans.

Firmware update is required
Your printer must have a bootloader to use PH4


You will be able to update the firmware using one of the 440 different setups
you can find by clicking here
.


Cabling update is required : from stock to custom cables with Creality compatible connectors.


Compatibility table

DDX PH4 Upgrade KitsCompatible with
DDX PH4 24v 300C for Ender 5 Ender-5 (with bootloader) and Ender-5 Pro units
with DDX and Copperhead™ or Mosquito™ hotends.
DDX PH4 24v 300C for CR-10(S)Pro/Max CR-10S Pro, CR-10S Pro v2, CR-10 Max,
and Ender-3 Pro units
with DDX and Copperhead™ or Mosquito™ hotends.

The DDX enables to raise the max nozzle temperature of the compatible Creality 3D printers up to 300°C, using these PHase 4 upgrades, that give new thermistor, heater and firmware to the setups.

Marlin 2.0 Customization

If you have the technical knowledge and want to customize Marlin 2.0 to flash your printer with, use the following values to define the temperature sensor:

  • For Slice's 300°C thermistor : #define TEMP_SENSOR_0 5
  • For Slice's 450°C thermistor : #define TEMP_SENSOR_0 67

Check for all the firmware update options here.