PH3 Mosquito™ Magnum Upgrade - DDX Direct Drive eXtruder for Creality

Use this adapter set to fit the Creality original Thermistor into a Copperhead™ or Mosquito™ Hot Block.

Applicable to Phase 2 and Phase 3.

Know more about the 4 Phases of DDX here:
The 4 Phases of DDX

Recommendation: Use on high flow applications.
(thick nozzles and thick layers)

<b-- Now with new version --

Revised Features

• New heat break with reinforced throat and revised radiator to prevent damage during installation and repairs
• New heat sink with wider opening for the filament path to more readily accept multi-material setups like the Prusa MMU or Mosaic Palette.

Main Benefits

• The Mosquito Magnum prints up to 20% faster than any other hotend on the market

• A thermal insulator protects the extended melt zone from the effects of active cooling, and radiative heat loss. It has a heat transmission rate as low as 3 W/m*K, meaning you can have ultimate confidence in the speed of your print, while at the same time maintaining the high resolution benefits achieved with the standard Mosquito
• The melt zone is extended proximally upwards to maintain a small form factor
• A multi extrusion setup with both high flow and high resolution optimized designs can be created without needing to purchase new nozzles or make carriage modifications to accommodate hotends of different sizes

Oh yeah, and you can change the nozzle with one hand.

Mosquito Magnum is only available for 1.75 mm filament at this time.

To use with:

• Bondtech DDX Direct Drive eXtruder for Creality

This set is necessary to install a Mosquito hotend in a DDX Upgrade Kit