fbpx

Bondtech Bowden Upgrade Kit for CR-10S needs PTFE tube pieces

Bondtech

/

Anonymized Chats Transcript

/

CR-10S extruder mount needs PTFE tube

CR-10S extruder mount needs PTFE tube

Conversation started on Friday, February 21 2020, 13:57


[13:58] Customer : Hi, the printed CR-10S Bowden Mount needs PTFE tube inside?


[13:59] Bondtech : Yes a short section pushed into the mount in order to avoid wear of the mount itself.


[13:59] Customer : Guess i have to remove it again 😀


[14:04] Customer : I can’t press it in?


[14:04] Bondtech : Yes that is how we do it


[14:04] Customer : The hole seems too small.


[14:05] Bondtech : It is smaller at the surface, this way it will be kept in place


[14:06] Customer : Does it need to go all the to the other side?


[14:06] Bondtech : No, cut a piece 4 mm long and push it in


[14:09] Customer : Does it need a small piece on both sides?


[14:09] Bondtech : Correct!


[14:12] Customer : Thanks


[14:12] Bondtech : You are welcome!


Leave a Reply